Wolf PWC362418 Guida di Installazione Scaricare il pdf (Pagina 10)

Pro Wall Chimney Hood Installation 10

IMPORTANT NOTE: F

or wall chimney hoods using a

600 CFM or 900 CFM internal blower, the internal blower

must be installed before the transition is attached.

4) The hood assembly is shipped with the transition

attached. The transition is shipped upside down in the

top of the hood and must be removed and reinstalled

in the proper position. Separate the transition from the

hood by removing the four shipping screws. Invert and

reattach the transition with the shipping screws.

5) If you are installing an in-line or remote blower, punch

out the knockout hole located on the top of the hood.

Install a wire clamp (provided with hood) for the remote

blower cable. Install another wire clamp in the hole on

top of the hood for the Romex

wire. Refer to the in-

line and remote blowers section on page 16 and follow

installation instructions provided with the blower.

Hood Preparation

) Remove the filters of the pro wall chimney hood by

pushing each filter up at the angle it is placed in,

then rotate the bottom of the filter down. Refer to the

illustration below. Remove the center filter first. Gloves

should be worn when handling filters.

2) Slide the grease cups out from the bottom edge of the

back of the hood.

3) Using a Phillips screwdriver, remove the four screws

retaining the hood’s internal frame shown in the

shaded area of the illustration below. Be sure to leave

the other two screws in place. Do not discard the

screws. They will be used to reinstall the internal frame

after installation is complete. Remove the internal

frame and set aside.

GREASE CUP

FILTER

SPRING

SIDE VIEW

Remove filters. Internal frame.

REMOVE

SCREWS

DO NOT

REMOVE

DO NOT

REMOVE

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 19 20

Commenti su questo manuale

Nessun commento

Wolf PWC362418 Guida di Installazione Pagina 10

Commenti su questo manuale

Prodotti e manuali riguardandi Cappa da cucina Wolf PWC362418